Changing the Retention Bracket
A. Press and hold the Intel retention bracket firmly towards the pump.
B. Rotate the Intel retention bracket counterclockwise to release.
C. Pull out the Intel retention bracket.
D. Follow these steps in reverse order to install the AMD retention bracket onto the pump.
Step of
Preparing the Backplate
Remove the stock AMD mounting bracket and keep the original backplate on the rear of the motherboard.
Step of
Installing the Pump
Place the pump with the retention bracket onto the CPU. Ensuring the standoffs go through the holes on the bracket and securely apply the thumbscrews.
Step of
Mounting the Radiator and Fans
For mounting in which the radiator fits directly onto the case, please install the fan(s) first using the 30mm fan screws.
Step of
Mounting the Radiator and Fans
Use the 5mm case screws and washers to mount the radiator.
Step of
Connecting the Power Cable Set
Connect the power cable set to the pump.
Step of
Connecting the Pump Tach
Connect the 3-pin connector on the power cable set to the 4-pin CPU_FAN connector on the motherboard.
Step of
Powering the Fans
Connect the fan cable to the first fan connector on the power cable set with 4 pins. Use the remaining fan connectors as needed.
Step of
Connecting the SATA Power Cable
Connect the SATA power cable on the power cable set to the SATA power cable from the power supply.
Step of
Connecting the USB Cable
Connect the Mini-USB cable from the pump to an available USB 2.0 internal connector on the motherboard.
Step of
YOU'RE DONE!
After setting up the Kraken, turn on your PC and proceed to download and install CAM software to enable Kraken controls!
Learn More → Download Now →