temperature reading thingy question

[CaptainSquirts]

b4 i stick nething on is it suppose to show anything and have a blue light or no? because its just a blank screen right now???

[Sir Mandrake]

When you apply power to the Lexa, your LCD display should show the ambient temperature around the probes. The temps should be the same. When you mount the probes onto a heat source they should display the temps of that device. If your disply remains blank, then its possible that you have a defective meter. send an email to service@nzxt.com , explain your problem and provide a proof of purchase and they will take care of you.

Thanks!

[CaptainSquirts]

how would i show proff lol i dont know how to... i do still have the box with my name and the shipping address would that be enough?

[CaptainSquirts]

also i was reading about it on this forum and a couple people said it wasnt plugged in??? so what wire would it be for the lcd screen and where does it go

[Sir Mandrake]

Theres a power connector attached to red & black wires... that run to the LCD display. This connector looks exactly like the power connectors on a standard power supply. Simply connect that to a power source and it should light up for you. If it doesnt then contact NZXT and they will fix you up. If you ar unable to scan or take a pic of your reciept or invoice to show purchase then Im sure a pic of the box with the shipping lable will do just as good.